Installation

Step-by-Step Guide for Installing ELEMENTA Peel and Stick Vinyls and decorative Vinyls Rolls and Wallpapers

1. Surface Preparation:

   • Ensure the surface is clean, dry, and free of dust, grease, or any other impurities.
   • If the wall has any irregularities, lightly sand it to create a smooth surface.

2. Measurement and Cutting:

   • Measure the area where you will install the vinyl and mark the dimensions on the back of the vinyl.
   • Use a ruler and a sharp utility knife to cut the vinyl to the desired size.

3. Alignment:

   • Position the vinyl on the wall to ensure proper alignment before peeling off the backing.
   • Use a level to check that it is straight.

4. Peeling Off the Backing:

   • Start by peeling off a small section of the backing, about 10cm.
   • Avoid touching the adhesive side with your fingers to prevent stains or loss of adhesion.

5. Vinyl Application:

   • Apply the peeled section of the vinyl to the wall and use a plastic spatula to smooth it out and remove air bubbles.
   • Continue peeling off the backing while applying the vinyl, smoothing it with the spatula as you go to ensure even adhesion.

6. Removing Air Bubbles:

   • If any air bubbles remain, use a fine needle to gently prick them, then smooth the area with the spatula.

7. Final Adjustments:

   • Trim any excess vinyl from the edges with a sharp utility knife for a clean, professional finish.

Additional ELEMENTA Tips:

• Work in a well-lit area to ensure the vinyl is applied evenly.
• If you're applying multiple pieces of vinyl, ensure the patterns align properly before attaching each piece.

With these simple steps, you can easily install your ELEMENTA peel and stick vinyl and transform your space quickly and effectively.